Northwest Dive Club

Anybody know of a good reputable mech?

dieseldude

Marine, vehicle, or equipment?

Vehicle has a on going problem. Dealer has seen the vehicle for the last time. Need somebody smarter. To much to post here. Will detail via PM or phone.

Ford...6.0?

+1 for Deiseldude... MJ's good...

deep diver wrote:Ford...6.0?

2003 cummins throws "0341 cam position sensor" fault code. I like the truck but nobody seems to be able to sort this out.

deep diver wrote:Ford...6.0?

2003 cummins 5.9 throws "0341 cam position sensor" fault code. I like the truck but nobody seems to be able to sort this out.

Hey, Rob!

I'm a + 2 for dieseldude here on the board. Mike's always done a great job on my Ford diesel. However, he left the business about a year or so ago. He is no longer affiliated with a shop (he used to be at the Ford dealer out in Snohomish) and may not be doing diesel work any longer. He definitely knows what he's doing under a truck hood. You could always drop him a PM to see what's possible and what isn't.

- John

Pm sent. Thanks for the info !

If you want help on a dodge this is the web site to look for answer. Dodge of Bellevue charged me $150, two trips 5.5 hours out of my time to screw up my speedometer on my 03 Cummins. I posted on this site and found someone who would fix it for free. I bought him dinner and it took less than 5 minutes. Here is the link. To have full access it cost $35. Well worth it.

http://www.turbodieselregister.com/

Greg

http://www.evergreendiesels.com/

i know bj goes here for service, and when i was looking for a diesel a lot of olks also recomended them.

You could try Gary at ONB Automotive in downtown Everett, he used to be at Motor Trucks. He was a master mechanic for years then Motor Trucks trained him for Diesels...